Custom Header Builds Just Got FUN!

0

As most of you may know, building custom headers is a major trial and error process. Massive amounts of time and material are wasted due to micro adjustments and tack welding, only to find your header is in contact with a frame rail or another element in your cramped engine bay. The cost of your job is rising faster than your blood pressure and your scrap pile isn’t getting any smaller. After hours in the shop with little progress, you find yourself back at the drawing board looking for a solution. The guys at Icengineworks know this process all too well and have come up with a header building system that puts the FUN back in fabrication. Some fabricators call it cheating, however if you ain’t cheatin’, you ain’t tryin’, right?

Icengineworks provides 3 categories of products that simplify the header building process. Their most popular product is the Header Modeling Blocks. These time saving blocks allow you to simulate an exhaust runner using plastic blocks built to specific radii and OD. Adapt your runner to the header flange on your motor and precisely maneuver around obstacles in your engine bay until you have created a model of your custom headers. This eliminates cut and weld adjustments that waste both time and material. Once you have a block model of your custom headers, use the Icengineworks Tube Cutting Jigs to cut pre bent U and J bends to match the radii of your block model. When you have all your pieces, recruit Icengineworks’ Tack Weld Clamps to get the job done.  Clamp and position your pieces to create the final product by using these easy to use clamps.

The video below explains and demonstrates how the Icengineworks system can save you both time and money. This video was shot at the 2015 PRI Show and highlights the major advantages of the Icengineworks products.

 

Share.